Copy/Paste/Delete Table & Section etc.

flds · #25 07-06-2011, 12:49 PM

Hi Paul,

Thanks for the code I tried it. It still requires a few fixes.

Following is the feedback from the code I ran.

- Text – Output is fine, if not for the what happens in the output of “Design Requirement”
- Tables are fine
- References is fine, only thing is that it includes pictures and figures, need to be deleted. Pictures and figures are not required in any of the output folder.
- Outline is fine.
- Appendix is fine
- Design Requirements – output gives me all the section, it should only copy the section, “Design Requirements” (i.e Section 4 and section 8, in the example below). It also re-numbers the section, which should not happen. The section numbers should remain the same.
For example.
I have sections as follows 1. Introduction, 2. System Description , 3. Material Description, 4. Design Requirements, 5. Code and Standards, 6. Safety Requirements, 7. Operations, 8. Component Design Requirements, 9. Overpressure Protection, 10. References and followed by Appendices.

If the picture and figures are deleted and “Design Requirements” part is fixed then this is exactly what I want.

I hope you will be able to do this fix. If you need more clarification let me know.

Thanks for your time and affords.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
copy and paste not working	Ellie	Word	3	11-07-2013 02:23 PM
Can't copy paste	irenasobolewska	Office	2	10-26-2012 05:09 PM
Copy - Paste between 2 tables	rod147	Excel	1	10-22-2009 08:21 PM
Copy & paste low resolution	worriedme	Drawing and Graphics	0	06-01-2009 03:05 AM
Copy and paste special	Dace	Excel	2	02-16-2009 12:18 PM