That is a tricky little shape with lots of moving parts so it is hard to describe the various pieces that have to change.

I've amended it along the lines you asked for and added a couple of other settings so you can also vary the spacing and length of the lines.

If you want to study the changes I made:


Master shape - see ShapeSheet sections: Controls, User Defined, Shape Data
Child Shapes - see ShapeSheet sections: 1-D Endpoints, Geometry 1

Attached Files

Cable Stencil.zip (21.2 KB, 4 views)

__________________
Andrew Lockton
Chrysalis Design, Melbourne Australia

Awesome, you're amazing. Thank you for the response it's very appreciated! I'll definitely look into the changes. I believe I was close to getting it, but I was missing a little detail somewhere.

Again, thank you for the previously reply. After finally getting around to test the stencil out Wire-2 acts kind of funky. See attached picture. It is ONLY Wire-2. I can't figure out why the elbow part of it goes the opposite direction it should.

Also, if I wanted to add 2 more wire slots do I just create more rows in the shape sheet? I just can't seem to figure out where the drawing of the wire is done in the shape sheet.

Thanks for any help

Attached Images

Wire-2.png (25.0 KB, 10 views)