Thanks for the feedback Macropod.



I tried to add the function to the Word.dot file - but just get a msgbox with Blank.

Not sure i'm putting the code in properly;

I loaded the .dot document - it came up with the message to say that opening was going to run a command Select * etc etc ...

If I say YES then says Data Source not found; if i say No it opens.

1st tried to just add it into a code module in the .dot file - then Run thru debug...Msgbox says Blank

Then - added a button to the .dot document and put the code on it and selected Exit Design Mode - clicked the button - This time said that it wasn't a merge document.

I've renamed one of the the .dots to a .doc and attached to this message...

Your help is much appreciated

Phil

Attached Files

Confirmation Effective Supervision jr.doc (44.0 KB, 12 views)