How to make a "modular" stencil

[BobbyS]

Awesome, you're amazing. Thank you for the response it's very appreciated! I'll definitely look into the changes. I believe I was close to getting it, but I was missing a little detail somewhere.

[BobbyS]

Again, thank you for the previously reply. After finally getting around to test the stencil out Wire-2 acts kind of funky. See attached picture. It is ONLY Wire-2. I can't figure out why the elbow part of it goes the opposite direction it should.

Also, if I wanted to add 2 more wire slots do I just create more rows in the shape sheet? I just can't seem to figure out where the drawing of the wire is done in the shape sheet.

Thanks for any help