Hi Paul,
I must apologize. My previous post was wrong. I tried to quickly get it submitted before I left for the day, copied and pasted forgetting to make the necessary changes.
This is what I have.
Product ID: {FORMDROPDOWN} containing: Blank space, BDR, BDO, etc. Roughly 25 different engine types.
C_EPD_Overspeed_Limit = {IF{REF ProductID}="BDR""2650 rpm"}
C_EPD_Overspeed_Error_Reset = {IF{REF ProductID}="BDR""2300 rpm"}
C_EPD_Overspeed_Allowed_Time = {IF{REF ProductID}="BDR""0.26 s"}
C_EPS_n_ASICOverspeedLimit = {IF{REF ProductID}="BDR""2750 rpm"}
C_EPS_n_ASICOverspeedReset = {IF{REF ProductID}="BDR""2290 rpm"}
T_DIP_Key_Switch_RLOC = {IF{REF ProductID}="BDR""240"}
I bookmarked each of these: C_EPD_Overspeed_Limit, C_EPD_Overspeed_Error_Reset, etc.....
Using the open loop engine speed control feature of the tester, set the engine speed such that _Engine_Speed = _____________.
I will need to change the time and change the rpm values according to the feature being tested within each separate engine type, so the math will change through out the procedure.
Here is where I want to add +10 and later on in the document I would like to -10, I also need it to clear. How would I go about this?
Thanks!
|