Hi Paul,

Thanks for your reply.

I replaced and changed the lines as mentioned and test run the code. NO success.

I am adding an outline of a document as an example, to give you an idea what is required.
I need complete sections of 2 (Design Requirements) and sections 7 (CONTROL DESIGN REQUIREMENTS) ONLY.

This example is not in all documents,
- in ALL documents one section is always as section 2,
- in some document it may be as sections 2 and 7
- in some documents it may be as Section 2, 7 or as section 10. Design Requirements Process Systems
The words “DESIGN REQUIREMENTS” is common.

Document Outline

1. INTRODUCTION


2. Design Requirements

2.1 Functional Requirements

2.2 Performance Requirements

2.2.1 Warm-Up

2.2.2 Start Up

2.3 Safety Requirements

2.3.1 General


3. PROCESS SYSTEM DESCRIPTION

3.1 General

3.1.1 System Arrangement

3.2 Equipment Description

3.2.1 Steam Generators

3.2.2 Heat Transport Pumps

3.2.2.1 General


4. Commissioning

4.1 Hydrostatic Test

4.2 Pump Operation without Fuel in the Reactor

4.2.1 General


5. OPERATION

5.1 Operating Conditions

5.2 Normal Operation


6. PROCESS DESIGN CONSIDERATIONS

6.1 Heat Transport System Operating Conditions

6.2 Fluid Velocities


7. CONTROL DESIGN REQUIREMENTS

7.1 General

7.2 System Classification

7.3 Safety Requirements

7.3.1 General

7.3.2 Seismic Qualification and PAM Requirements


8. CONTROL SYSTEM DESCRIPTION

8.1 General

8.2 Heat Transport Pump Motor Control


9. REFERENCES

9.1 System Flowsheets

9.2 Design Manuals


Appendix

I hope this will explains my requirements
Thanks
FLDS