Converted PDF to Word - Editing nightmare!
Hi everyone,
I'm looking to see if there is a better way to edit a large document that was converted from a report we produced where the software generated a PDF file. I converted the PDF file into Word (I know this is not always good) but all the tables and pictures are there and in the correct place. The problem I have is that I want each image scanned and its info on one page but the PDF generated it in two pages. Right now, in order to remove the page breaks, the continuous breaks, etc... I have to go through about 20 steps. I was wondering if anyone can take a look at the sample pages I've attached to tell me if there's a simpler way of doing this. The entire report has 454 pages, if I do it this way it's going to take forever! Thanking you in advance for looking. The last page in the report is what the final report for each IR scan should look like.
I tried setting tabs, deleting "Section Breaks", "Section Breaks Continuous", "Column Breaks", "returns", etc.. and again the results I want can only be achieved through about 20 steps!
Any help and a detailed step-by-step instructions on simplifying this process would be greatly appreciated. THANK YOU.
|